80%
/The drivers must be loaded for the PV132T before checking for connectivity with Windows 2000 native backup.

*  True. 
   False. 


/The PV132T takes up ________ U space in a Dell rack.

  seven 
* four 
  two 
  one 
(OK)


/The default IP address for the RMU in the PV132T is:

  10.0.0.2 
  172.16.0.201 
* 0.0.0.0 
  10.10.10.10 
(OK)


/When viewing the PV132T from the back, if there is only one tape drive, it must be plugged into the second tape drive slot located to the left.

* True. 
  False. 



/On the PV132T operator panel, which menu displays the current firmware version?

  Setup.
  Tools. 
* Status. 
  Command. 
(OK)


/To set the tape library's RMU IP address through the front operator panel on the PV132T, select the following screens:

* Setup. 
* RMU 
  Command. 
* IP Address. 
(¸Â´Â°Å °°À½)


/Remove the following components before removing the power supply on the PV132T:

* Ethernet cable from RMU. 
* RMU. 
* Power cord. 
  SNC module. 
(OK)


/What must be done before removing a magazine from the PV132T tape library?

  Ensure the backup software is set to the door lock position. 
* Ensure the keylock is unlocked. 
* Ensure the tape drive is not in use. 
  Unplug the AC power cord. 


/The cable attached to the barcode scanner plugs into the back RJ11 connector inside of the PV132T tape library.

  False. 
* True. 

 
/To remove the power supply on the PV132T, first remove the following components:

* The AC power cord. 
  The top cover. 
  None of the above. 
  The SNC module. 

 
Disconnect the following components before removing the SNC from the PV132T:

* Ethernet cable. 
* SCSI cables. 
* AC power cable. 
  SCSI terminator. 


/Which of the following FRUs should be removed from the PV132T when replacing the system chassis?

* RMU. 
  Front bezel. 
* Tape drive. 
* Bar code scanner. 
¸Â´Â°Å °°À½
 
/Pull the release button on the SFP before pulling the SFP away from the PV132T.

  False. 
* True. 
(¸Â´Â°Å °°À½


/Remove the following components before removing the RMU from the PV132T:

* Serial cable. 
  Fibre Channel cable. 
  SNC module. 
* Ethernet cable. 


Use the following to remove the two screws that secure the barcode scanner to the PV132T:

  #2 Phillips-head screwdriver. 
* #1 Phillips-head screwdriver. 
  T8 Torx driver. 
  T10 Torx driver. 
(OK)


The library robotics SCSI ID is 0 and it is connected to the SCSI bus through the first tape drive.

* True. 
  False. 


/A flat-blade screw driver is used to do the following when removing a power supply from the PV132T: 

   Unscrew the four screws that secure the power supply. 
* Pry the power supply from the chassis. 
 Loosen the thumbscrews. 
 Remove the RMU.