=The drivers must be loaded for the PV132T before checking for connectivity with Windows 2000 native backup.

=   True. 
 False. 


The PV132T can be mounted in a Dell rack using:

   Cage nuts. 
 Slide rails. 
 Versa rails. 
= Rapid rails. 


The library robotics SCSI ID is 0 and it is connected to the SCSI bus through the first tape drive.

==   True. 
 False. 



The default IP address for the RMU in the PV132T is:

   10.0.0.2 
= 0.0.0.0 
 172.16.0.201 
 10.10.10.10 




On the PV132T operator panel, which menu displays the current firmware version?

   Command. 
 Status. 
 Tools. 
== Setup. 



To set the tape library's RMU IP address through the front operator panel on the PV132T, select the following screens:

==   RMU 
== Setup.
 Command.    
== IP Address 



Which of the following components should be left in the chassis when replacing the PV132T chassis?

   Operator panel. 
= RMU. 
 Picker assembly. 
 Front bezel. 



Remove the following components before removing the RMU from the PV132T:

=   Serial cable. 
 Fibre Channel cable. 
 SNC module. 
= Ethernet cable. 



To remove the power supply on the PV132T, first remove the following components:

   The SNC module. 
 The top cover. 
 None of the above. 
= The AC power cord. 



Disconnect the following components before removing the SNC from the PV132T:

=   SCSI cables. 
= AC power cable. 
 SCSI terminator. 
= Ethernet cable 



Which of the following FRUs should be removed from the PV132T when replacing the system chassis?

==   RMU. 
== Bar code scanner. 
== Tape drive. 
 Front bezel. 



****What must be done before removing a magazine from the PV132T tape library?

==   Ensure the tape drive is not in use. 
 Unplug the AC power cord. 
= Ensure the keylock is unlocked. 
 Ensure the backup software is set to the door lock position. 

 
A flat-blade screw driver is used to do the following when removing a power supply from the PV132T: 

   Pry the power supply from the chassis. 
 Loosen the thumbscrews. 
= Unscrew the four screws that secure the power supply. 
  Remove the RMU. 



Remove the following components before removing the power supply on the PV132T:

 =  Power cord. 
= Ethernet cable from RMU. 
 SNC module. 
= RMU. 



Use the following to remove the two screws that secure the barcode scanner to the PV132T:

   T8 Torx driver. 
= #1 Phillips-head screwdriver. 
 #2 Phillips-head screwdriver. 
 T10 Torx driver. 



The PV132T takes up ________ U space in a Dell rack.

 two 
 seven 
 one 
= four 





When viewing the PV132T from the back, if there is only one tape drive, it must be plugged into the second tape drive slot located to the left.

==   True. 
 False. 




Pull the release button on the SFP before pulling the SFP away from the PV132T.

==   False. 
 True. 



The cable attached to the barcode scanner plugs into the back RJ11 connector inside of the PV132T tape library.

=   True. 
 False.