93Ǫ·Î


The drivers must be loaded for the PV132T before checking for connectivity with Windows 2000 native backup.

=   True. 
 False. 


??The PV132T can be mounted in a Dell rack using:

 x  Slide rails. 
=  Rapid rails. 
= Versa rails. 
x Cage nuts 


The default IP address for the RMU in the PV132T is:

   10.10.10.10 
 10.0.0.2 
= 0.0.0.0 
 172.16.0.201 


When viewing the PV132T from the back, if there is only one tape drive, it must be plugged into the second tape drive slot located to the left.

   True. 
= False 


To set the tape library's RMU IP address through the front operator panel on the PV132T, select the following screens:

= IP Address. 
= Setup. 
= RMU 
  Command. 


On the PV132T operator panel, which menu displays the current firmware version?

   Command. 
 Tools. 
= Setup. 
 Status. 


Disconnect the following components before removing the SNC from the PV132T:

   SCSI terminator. 
= Ethernet cable. 
= SCSI cables. 
 AC power cable. 


 Which of the following components should be left in the chassis when replacing the PV132T chassis?

=   Operator panel. 
 =Picker assembly. 
 =Front bezel. 
 RMU. 


What must be done before removing a magazine from the PV132T tape library?

 =  Ensure the keylock is unlocked. 
 Ensure the backup software is set to the door lock position. 
 Unplug the AC power cord. 
= Ensure the tape drive is not in use. 


Remove the following components before removing the power supply on the PV132T:

=  RMU. 
= Ethernet cable from RMU. 
 SNC module. 
= Power cord. 


To remove the power supply on the PV132T, first remove the following components:

=   The AC power cord. 
 The SNC module. 
 The top cover. 
 None of the above. 


Pull the release button on the SFP before pulling the SFP away from the PV132T.

   True. 
= False. 

 



A flat-blade screw driver is used to do the following when removing a power supply from the PV132T: 

=   Pry the power supply from the chassis. 
 Loosen the thumbscrews. 
 Remove the RMU. 
 Unscrew the four screws that secure the power supply. 



Which of the following FRUs should be removed from the PV132T when replacing the system chassis?

=   RMU. 
 Front bezel. 
= Bar code scanner. 
= Tape drive. 



Remove the following components before removing the RMU from the PV132T:

=   Serial cable. 
 Fibre Channel cable. 
= Ethernet cable. 
 SNC module. 



The PV132T takes up ________ U space in a Dell rack.

   seven 
= four 
 two 
 one 


Use the following to remove the two screws that secure the barcode scanner to the PV132T:

=   #1 Phillips-head screwdriver. 
 #2 Phillips-head screwdriver. 
 T10 Torx driver. 
 T8 Torx driver. 


The cable attached to the barcode scanner plugs into the back RJ11 connector inside of the PV132T tape library.

   False. 
= True 


The library robotics SCSI ID is 0 and it is connected to the SCSI bus through the first tape drive.

=   True. 
 False.