** Unless they are installed with a full-height adapter, low-profile I/O cards will go into which I/O slots? 1,2,3 (riser 1) \\ 6,7 (riser 3) 4,5 (riser 2) ** There are a number of ways to identify a failing power supply. Please select the correct ways from below. The indicator handle turns amber \\ In the BIOS In the system storage center \\ An alert will be sent ** After replacing the SC8000 chassis, what should be done in the Cache tab of the System Storage Center Manager? Enable Read Cache \\ Enable Write Cache \\ Flush the cache Disable Cache Alerts ** When replacing the controller, what parts MUST be retained from the existing controller? (choose 2) IO Cards CHA3 Cache Card \\ SD Card \\ Memory ** The CHA3 cache card is defined as: A PCIe battery-less non-volatile (NVDIMM) card \\ A PCI Memory card with battery backup A PCIe card that houses an SD card slot and a battery for back up A PCIe flash disk card ** The SC8000 can have either a 16 GB or a 64 GB memory configuration. How many DIMM slots do both configurations use? 12 16 10 4 8 \\ ** What 2 things should you do before and after servicing an SC8000? Reconfigure the RAID array to ensure no data loss Turn on the SC8000 Perform a Phone Home action \\ Contact Dell Technical support enable/disable alerts \\ ** Which Risers in the SC8000 hold full-height I/O cards? Riser 1 Riser 3 \\ Riser 2 \\ Riser 4 ** Select two true statements about SC8000 power supply units (PSUs). Only 750W PSUs are supported \\ SC8000 PSUs are not removable The indicator handle stays green all the time even when powered off They are hot-swappable \\ ** What are the only two supported memory configurations for the SC8000? 32GB and 128GB 16GB and 64GB \\ 4GB and 32GB 8GB and 32GB 16GB and 128GB 8GB and 64GB ** What should you do before sliding the SC8000 out of the service position and back into the rack? Ensure that no one is behind the rack to avoid injury Ensure that the SD card is well seated as it can be jarred loose when you move the SC800i into the service position Ensure the system cover is on to avoid breaking the Intrusion Detection Switch \\ ** Where can you find the SC8000 service tag? On the motherboard On a label attached to the rear of the chassis \\ EST Panel \\ On the rack ** Where must you insert the CHA3 Cache card that ships with the SC8000 ? Slot 1 in Riser 3 Slot 4 in Riser 2 Slot 3 in Riser 2 Slot 7 in Riser 3 \\ Slot 7 in Riser 1 ** When you are replacing a part on the SC8000, what should you do before moving the system to the service position and opening the cover? Identify the failed part Remove the power cables to the SC8000 Perform a shutdown of the SC8000 \\ Disconnect the UPS ** The SC8000 Intrusion Detection Switch is located on which Riser? Riser 3 Riser 1 Riser 2 @@ ** If you are replacing an SD card with a new one, what is the main issue you MUST be aware of? Replacement SD cards do not ship with SCOS installed Replacement SD cards come in 2 sizes, 4GB and 8GB You can replace an SD card as 'hot-swappable' ** The SC8000 can house a maximum of how many I/O cards excluding the CHA3 cache card? 6 \\ 5 8 7 ** Where does the SC8000 have the SCOS (Storage Center OS) installed? On an internal SC8000 hard drive On the disks of the enclosure the SC8000 is connected to On the internal 8GB SD card \\ On a PCIe flash card ** When you are replacing a part on the SC8000, what should you do before moving the system to the service position and opening the cover? Identify the failed part Perform a shutdown of the SC8000 \\ Remove the power cables to the SC8000 Disconnect the UPS **If you are replacing an SD card with a new one, what is the main issue you MUST be aware of? Replacement SD cards do not ship with SCOS installed \\ You can replace an SD card as 'hot-swappable' Replacement SD cards come in 2 sizes, 4GB and 8GB